Subject: N512SR begins taxi-testing
From: Rotary Engine
Date: 5/2/2009, 6:41 PM
To: AAA Put this in the To box


N512SR took a jaunt around the airport under her own power for the first
time today, including a visit to the main runway to see if she wanted to let
her tail fly.

K00V was completely socked in by fog all day, and lacking any instrument
approaches or departures, we thought it was a splendid day to give it a
whirl without getting in anyone's way.  After getting the exhaust system
redesigned & relocating the O2 sensor, the engine ran quite well.  For the
first time, we started seeing O2 readings that responded predicatbly to
manual mixture variations.  Needs some MAP adjustment at the low end, but
for the first time we were able to run smoothly above 5000 rpm.  The much
smaller exhaust tube noticeably reduced engine noise, but I still wouldn't
call the engine quiet.  All told, she wandered around the airport for 15
minutes or so.  Max oil and water temps during this time were about 180F.
She got up to 40mph indicated on the runway, but the brakes / main gear
alignment had her moving a bit squirrely, so Terry didn't try to get the
tail up.  Terry reports temps dropped while rolling down the runway.  EGTs
peaked a little shy of 1200F

The forward pport tube is leaking steadily unfortunately.  There is no
indication of leakage inside the engine (no white smoke to be seen & no
fluid ejected while hand propping) but the fluid level leading to the water
pump is dropping steadily.  Looks like the fluid gets cooked off as it leaks
while the engine is running (thus no puddles or drips while running).  Fluid
puddles on the top of the exhaust flange after running, indicating it leaks
even with no water pressure.

Absent the pport leak, we'd be gearing up for first flight.

Mark (Rocky Mtn High)


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.