Subject: P-port Manifold pressure tap
From: Rotary Engine
Date: 5/7/2009, 2:04 PM
To: AAA Put this in the To box

If anybody is planning a p-port and planning on using
Tracy's efi system a good place for a manifold pressure tap
is the oil injection hole. They close off right after
the apex seal passes the top of the p-port.

There may be a bit of turbulence under part throttle conditions
with the pressure taps located behind the slide. That could explain why
Tracy's manifold pressure measurements are so illogical other than
he is using only one brief sample at some unknown time in the cycle.

Air is always flowing back and fourth every where inside the manifold.
In a 13B p-port when the apex seal passes the bottom of the intake port
there is a wide open passage to the exhaust system. If the pressure in the
exhaust system is higher than the intake system exhaust gases will flow from
the exhaust system up into the intake system. This is the main reason the 13B p-port
is so erratic at speeds lower than about 4500 RPM. It is also the reason
you want to keep the throttle mounted close to the rotor housing so the entire
intake system is not filled with exhaust gases. Even though the manifold
pressure might be high that does not mean the gases are all pure fresh air.
Exhaust gas does not burn so in effect the mixture becomes extra
rich because the computer thinks there is more combustible air in there
than there really is... based just on the manifold pressure gage reading.
A mass airflow sensor based system (555) would not suffer from this as the
mass air flow sensor is way upstream and sees only fresh air.

At higher RPM and wide open throttle and when the intake
system is on the pipe so to speak the 13B p-port comes into its own and
good things start to happen. It becomes much like a continuous combustion
turbine engine. The inertia of the incoming air minimizes the mixing of
exhaust gases just like in a turbine engine. Just don't expect much below 4500 RPM.
Fortunately with a fixed pitch prop the HP demands on the engine are
minimal below 4500 RPM. You just want to keep it running and running
as smoothly as possible.

This does not apply to an RX8 P-port as the side exhaust ports block
much of the reverse exhaust gas flow. Just like a side intake P-port
exhaust stock 13B RX7 engine.


Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.