Subject: Tuned intake manifold pressure test.
From: Rotary Engine
Date: 5/7/2009, 4:53 AM
To: AAA Put this in the To box

The five volt on board power supply this thing comes with
makes it real easy to wire up.

Here is the results of the first pressure sensor test. I used
a hand vac pump to reduce the pressure from sea level
to about 26 to 27 inches of Hg vac.
The numbers at the bottom of the chart are the sample numbers at
1000 samples per second. Data rez is to the nearest 1/1000 of a volt.
Sea level is 1.8 something while full scale is close to 4.1 volts.

This thing is real easy to use.

-----------------------------------------------------

Well I got it all together. I used another analog
channel to serve as a TDC mark using the Mazda 2nd gen
RX7 Crank Angle Sensor.

I took the gear off the CAS so I could drive it with
a rubber band belt from a drill motor. I got it up
to 2000 RPM.

  The output of the 2nd gen CAS looks just like an
RX8 CAS or a anti lock brake system sensor. They all use the same
principle.

I used an opto isolator for the trigger signal as I did not
want to risk grounding problems. The positive part of the trigger
pulse turns on the LED which turns on the photo transistor which inverts
the pulse. That is why it goes negative.

------------------------------------------------
This last plot is only .4 seconds worth of data taken at 2 milli seconds
apart. Truly amazing. A super high speed camera shot of what is going
on in the intake system. The blue and red lines are the pressure sensors not connected
to anything. The yellow line is the trigger from the 2nd gen
crank angle sensor. The yellow pulse happens at E-shaft top dead center.
You can see the drill motor accelerating on the left of the chart.
It peaked out at 2000 RPM.

I can hardly wait to test Mark's P-port engine. 1800 RPM to 6600 RPM.
To my knowledge this is the only time, since the book, Scientific Design of Exhaust
and Intake systems was published in 1962, this level of data was available.
In those days they used an ingenious rotary valve driven by the crankshaft
to measure the pressure data from an intake or exhaust manifold using
18 U tube manometers.

We will have data over a wide range of RPM's which was not available in the
book. Mazda published just a snap  shot of one cycle at one RPM of a p-port
engine probably using an O-scope.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.