Paul

Can you send me a J-Peg file? I want to make sure mastercam is
interpreting this drawing correctly. I opened it in Solid Works
but a couple of things look funny. there seems to be a couple of
surface import errors. Overall should be easy to make. What do I
do with it once it's done?

Tony

Well we need to get some cheap castings made because it is
too expensive to make them one at a time on an NC mill I think.
I could be wrong depending on what you would charge :)
It would be nice to have a couple original size to test.

Here are the jpgs.

Paul Lamar

How much machining work will be required on the housing to fit this
casting to it?


Regards,

Matt-

Other than boring the 2 inch hole through both parts not much.
Some of the extensions on the housing need to be machined down.
The mill set up will be the same. That is what takes most
of the time.


Paul Lamar