I just ran across this data on the 2nd gen RX7 mass airflow sensor.?
Bosch wrote it up as part of the L jetronic injection system manual.
I suspect it is made by Denso under license and installed
in 1986 to 1991 RX7's. I don't think it is a computer.
I think it is similar to a 555 system. All hardware and no
software.
Perry Mick has been flying this system for years in his Long EZ
with hundreds of hours.
It is very reliable. He has tricked the ECU into thinking it is
still in car. He has even installed an RX7 instrument panel
in the cockpit.
There are probably over 100,000
of these systems out there. They are real cheap I suspect.
Paul Lamar
Paul,
This may not be doable for Aviation and I have no doubt that someone will
tell me why, however all ideas should be explored if only to eliminate them
IMHO. Now some motorcycle carbs have floating slides whereby the density of
the incoming air varies the slide compared to the throttle position - for
altitude compensation. I can't remember exactly how this is accomplished by
lifting the slide with the incoming air. There is a sloped face which is
supposed to have a critical angle to accomplish this task. It may be there
is a calibrated spring that air density is pushing against.
This is the simplest solution air density adjustment I have heard about.
For your consideration.
George ( down under)
George, and group,
All ofwhat are called "vacuum slide" carburetors have this feature. These
are the type of carbs used on the Jabaru engines.In their case the carbs are
manufactured by Bing, but some version of the vacuum slide carb has been
made by just about everyone. Bing, Mikuni, Kehin,Stromberg, SU, and many more.
The only bad thing about these carbs is that they always have a
butterfly downstream from the vacuum slide. there is a port just past the
butterfly valve that is ported above the diaphram or vacuum piston that
raises the vacuum slide. The piston or diaphram lifts the slide which
also carries the mixture needle, making the carb somewhat self adjusting.
These carbs work fairly well, but due to all the mechanism in the bore they
are more restrictive for a specific bore than typical carbs.
Bill Jepson
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.