Subject: 2nd gen mass airflow sensor. Low cost.
From: Rotary Engine
Date: 5/14/2009, 6:30 PM
To: AAA Put this in the To box


 I just ran across this data on the 2nd gen RX7 mass airflow sensor.
  Bosch wrote it up as part of the L jetronic injection system manual.
  I suspect it is made by Denso under license and installed
  in 1986 to 1991 RX7's. I don't think it is a computer.
  I think it is similar to a 555 system. All hardware and no
  software.

  Perry Mick has been flying this system for years in his Long EZ
  with hundreds of hours.

  It is very reliable. He has tricked the ECU into thinking it is
  still in car. He has even installed an RX7 instrument panel
  in the cockpit.

  There are probably over 100,000
  of these systems out there. They are real cheap I suspect.

  Paul Lamar

 Paul,
 This may not be doable for Aviation and I have no doubt that someone will
 tell me why, however all ideas should be explored if only to eliminate
 them
 IMHO. Now some motorcycle carbs have floating slides whereby the density
 of
 the incoming air varies the slide compared to the throttle position - for
 altitude compensation. I can't remember exactly how this is accomplished
 by
 lifting the slide with the incoming air. There is a sloped face which is
 supposed to have a critical angle to accomplish this task. It may be
there
 is a calibrated spring that air density is pushing against.

 This is the simplest solution air density adjustment I have heard about.
 For your consideration.
 George ( down under)

 George,
 My motorcyle has these. Tuned for sea level, it runs rich when going over
 the Sierra's.
 If you tune it for Denver, pings like crazy at sea level.....
 The slide is lifted pulling the mixture needle out of the jet by the low
 pressure area created by the air flowing by an orfice in the bottom of
the
 piston.
 The top of the slide has a larger piston (or diaphram) and the vac on the
 top side pulls the slide up. But they are not density sensitive.
 Sorry.....
 Larry


 Larry,
 I disagree, there is a degree of self adjustment when crusing. There will
 obviously be a POWER loss as I'm sure you are aware. There are limits,
 because the diaphragm is frequently over sized so the slide will respond
 quickly, many sudden throttle openings, (like driving in traffic), will
 show rich on the plugs. Steady state crusing will lean after you reach
 steady state. With respect to aircraft, the carbs will work better than
 the
 motorcycle use since throttle openings don't change very quickly. For
 leaning that is

 Bill Jepson

Thanks Bill, Larry, Matt & Vlad.
There certainly are some interesting points, food for thought. Not as
simple
as I first thought.
Never heard about lowering the jet instead of raising the needle Matt, my
initial thoughts are that it may raise some sealing issues as the fuel
goes
through the jet - probably some O-rings involved. My idea of raising the
needle may well need some O-rings as well
I guess I will have to keep thinking.
George (down under)


Bill,
you are correct in there is some degree of self adjusting, being a rung up
the ladder from the typical booster venturi carb design.
hot wire mass air is just further up the ladder.
Larry


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.