There are a few flaws in this paper.
There are also some amazing contentions.
One of the most amazing things is this engine
is only 80 cubic inches. CW, John Deere or RPI
never made any 80 cubic inch rotary engines.
When this paper was written there were plenty
of Mazda rotary engine lying around that could
be modified to test a turbo compound rotary.
Therefore I suspect what it really is
... is a 160 cubic inch (2.6L) Mazda 13 B running at 8500 RPM
with a total power out of 400 HP in turbo compound form.
See page 171. There are lots of 400 HP 13B engines
out there without turbo compound.
The next one that caught my eye was page 183.
The turbine power is as much as 90 HP!!
There are some assumptions about the inter cooler that
may be flawed. The inter cooler chosen appears to be off
the shelf old fashioned plate and fin with less than optimal
performance given todays level of inter cooler technology.
The real power
out of the engine alone is really only 320 HP which is
a very modest amount for a turbo rotary. Stock
late model turbo charged RX7 3rd gens were 280 HP.
The rest of the 400 HP comes from the turbine.
Assume for the moment the net power out of the turbine
going back into the e-shaft is only 80 HP. 10 HP is being used
by the compressor. This is probably a side port engine so
there is some pumping losses that would not be present in
a p-port version.
So the engine is burning 320 HP worth of fuel at a BSFC of .47
or 150 pounds per hour or 24 gallons and hour.
The net BSFC would be 320/400 times .47 or .376 BSFC !!!!!
Better than a diesel!!!!
I would love to have one of these engines in my RX8 :)
It should bolt right in.
Too bad NASA never built the hardware and tested the engine on a dyno.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.