Here is a part you are going to need if you run Tracy's
EFI system with a p-port. This screws into the apex
seal oil injector port. It has a 10 mm 1.25 thread.
The hose barb is for about 3/16 ID vacuum hose.
The small hole is about .050 diameter to damp the
pressure pulses. This works like a charm and it is possible
to idle the p-port down to about 1500 RPM.

Paul Lamar


Paul, If you still plan to make any of these, I'll take a couple...

Thanks,
Rick in Alaska


I am pretty sure it won't take long. All depends on getting them
in the NC lathe job que.

Paul Lamar