EFI system with a p-port. This screws into the apex
  seal oil injector port. It has a 10 mm 1.25 thread.
  The hose barb is for about 3/16 ID vacuum hose.
  The small hole is about .050 diameter to damp the
  pressure pulses. This works like a charm and it is
 possible
  to idle the p-port down to about 1500 RPM.

  Paul Lamar


 Paul, If you still plan to make any of these, I'll take
 a couple...

 Thanks,
 Rick in Alaska


 I am pretty sure it won't take long. All depends on
 getting them in the NC lathe job que.

Paul Lamar


Count me for a pair 8-D !
C. Smith


Paul--Count me in for a pair also.

Thanks!
Paul Vermillion