Hi Paul,
I read your book on cooling wankel engines this weekend. What a wonderful
resource. Thank you for writing that. It was worth every penny.
I am probably going to end up with a Mistral engine. I just feel good about
it and what I have learned about the company and their product. There are
risks going with a new company. But the old piston technology is probably
equally risky for many reasons (elimination of leaded fuels, noise
complaints about old technology aircraft, and most important, the inherent
inferiority of piston engines compared to wankel with regard to reliability
- even though Mistral is new and did have that accident with the exhaust
which I looked into).
For my kitplane (Foxtrot) it looks like the cooling system will probably go
underneath the engine, per your Kay & London solution concept. But there is
a lot of stuff that I have to think out down there. Whatever I do, I'm
going to figure out how to beautifully integrate the cooling into the
airframe so it ends up stunning and low drag, but also state of the art for
all systems.
The Foxtrot airplane which we are building seems to have a fairly flat
surface under the cowl, which would probably be conducive to K&L radiator
concept. But the cowl is also very wide because it was designed for an IO
540 and also to make the cockpit wider for comfort. So there will be a lot
of thinking going on as we get more into the project and figure out how to
integrate the radiator with all the other stuff we want in the aircraft. We
of course don't know what brand or type of radiator we will use or how we
will build the scoops and ducts so they don't affect the airframe and fit
into the cowel.
Learning the basic concepts about the size of the air intake, expansion
after the air enters to reduce the air speed, developing pressure to get
through the radiator, and then making sure the air exhaust doesn't develop
drag were very powerful ideas. I need to read it again. Thank you for
writing it down for people like me. We're going to think everything out to
make sure we get an excellent solution for our airplane.
I was confused about the water manometer. Of course we don't need it very
soon. But it seems like something important to measure performance.
I'm thinking about a lot of other stuff for the airplane. But one
additional area is noise reduction. If you have any pointers there it would
be great. I remodel buildings and I always add noise reduction systems
(mass loaded vinyl, disconnect between components, etc.) So I want to add
that to my airplane, where it's more complicated but very important. I've
done the preliminary research but if anybody in your network knows some
practical stuff about this it would be great.
Your books was great and worth every penny. Thank you.
Bob Mayer
San Francisco
Thanks for the testimonial on the book. I can help you out in the
Foxtrot installation for free using Rhino 3D but I need some dimensions
of the firewall and the cowling.
Mistral latest installation uses the bottom radiator configuration.
Here are some pictures from the Aero show in Friedricshaven.
An endorsement on what we came up with a decade or so ago :)
Top heat exchanger is oil. Bottom is water.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.