GOOD EVENING PAUL

I ALREADY TAKE OUTSIDE PART ON THE ENGINE.

I AM SENDING YOU THE INTAKE AND WITH THE INJECTOR LOCATIONS 2 ON THE INTAKE
AND 2 IN THE MIDDLE SIDE PORT.

YOU CAN SEE THOSE 2 VACUUM CONTROL DEMPER,THE TOP ONE IS TO OPEN THE 2
PORT TOGETHER AND THE BOTTOM ONE SEEMS FOR THE CUT OUT DI IAM GESSING.

I WOULD LIKE STAYING WITH THE SIDE PORT SYSTEM AS POSSIBLE AND TRY
TO REUSE THIS INTAKE AND INJECTORS LOCATION, CAN I USE THE LOWER
DEMPER AS TROTTLE?? PHOTO OF THE SERVO ATTACHED.ONE OF THE
VELOCITY I BUILDED PHOTO ATTACHED

YOU SEE I AM NOT AN EXPERT ON ROTARY CONVERTION AND I NEED YOUR ADVISE

THANK,S


Jean Prudhomme


Yes you can. Assuming the EFI fuel injection can get the mixture
right. The HP however will be very modest as that is a four port
low power RX8 engine. My guess is around 150 HP if you are using
the 2.85:1 gear box and the proper prop.

BTW that engine is not sold anymore. Mazda discontinued it several
years ago.

Paul Lamar


SO YOU RECOMMEND GOING WITH P PORT AND WHAT KIND OF HP I WILL GET WITH THIS ENGINE??

Jean Prudhomme

Yes. 250 HP at 7500 RPM

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2008 All world wide rights reserved.