Subject: Low power 4 port RX8 tuned manifold. Plenum size?
From: Rotary Engine
Date: 5/31/2009, 11:02 AM
To: AAA Put this in the To box


In the type of intake plenum illustrated, what are the guidelines for
plenum volume as a function of flow rate and/or inlet diameter? And is
the projection of the inlet risers into the plenum a matter of tuning
(so that it would not be necessary if they had sufficient length outside
the plenum) or does it perform some other function?

Peter Garrison

Good question Peter and I would not begin to know where to start.
Perhaps CFD. Rumor has it the plenum should be as large as possible.
The Mazda Lemans winning 4 rotor race car had a very large plenum with
most of the variable length runners inside. I have no measurements on it
however.

Another possibility; if it is just the right size it acts as a Helmholtz
resonator. I suspect Porsche has investigated this principle and uses it
on some of their engines.

The tubes inside the plenum are there to provide adequate length for the
runners and still allow a large plenum. You will find that feature on
some race cars as mentioned above.


Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.