Subject: Engine Mount Request -- Bearhawk with 13B or 20B
From: Rotary Engine
Date: 6/9/2009, 2:30 PM
To: AAA Put this in the To box


 Paul,

 All the X & Y dimensions are from the flat firewall.
 Note there are five mounting points. Designer call for up to
 180hp with the four point, with up to 260hp with five
 points.

 I'm trying to get an idea of the room using either a 13B or
 20B. Only one Bearhawk is flying (Elden Yates). Little
 details, but Elden ended up putting his battery next to the
 PSRU to get some weight out on the nose!

 Plan is to use Tracy Cooks PSRU.  With 180hp, Bearhawk
 cruise is 140mph, with 260hp it is at 160 mph (75% on both
 numbers).

 --Tom

 There are five mounting points on the Bearhawk Firewall.
 Firewall is
 approximately 2" larger at all mounting points.

 In Inches:                 X        Y
 Lower Left        3.500    0.000    reference    Lower Right        31.188    0.000           Upper Left        0.000    20.188           Upper Right        34.688    20.188           Upper Middle        17.344    24.844                           THRUST LINE        17.344    15.844    Firewall
 set back at 6 degrees (top towards tail).
                        Prop Flange (front edge) to VERTICAL MOUNT -
 40.625"        Note, from firewall (6 degree lean back - top towards tail)
 is sin 6 *
 (Thrust Y position) or an additional
 1.656"          
 -- end of email ---


 Does this look right?

 Now you want me to lay it back 6 degrees?

 Paul Lamar


      Paul,

The bottom measurement should be changed from 27.500 to 27.688"

Upper middle is 24.844" from the lowest two holes.

Correct, rotate the firewall back 6 degrees. Point of rotation is from
the lowest two points on the firewall.

Thank You,

Tom

OK Tom Here it is.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.