Subject: Engine Mount Request -- Bearhawk with 13B or 20B
From: Rotary Engine
Date: 6/10/2009, 12:34 AM
To: AAA Put this in the To box




   Paul,

   All the X & Y dimensions are from the flat firewall.
   Note there are five mounting points. Designer call for up
  to
   180hp with the four point, with up to 260hp with five
   points.

   I'm trying to get an idea of the room using either a 13B
  or
   20B. Only one Bearhawk is flying (Elden Yates). Little
   details, but Elden ended up putting his battery next to
  the
   PSRU to get some weight out on the nose!

   Plan is to use Tracy Cooks PSRU.  With 180hp,
  Bearhawk
   cruise is 140mph, with 260hp it is at 160 mph (75% on
  both
   numbers).

   --Tom

   There are five mounting points on the Bearhawk Firewall.
   Firewall is
   approximately 2" larger at all mounting points.

   In Inches:
     X        Y
   Lower Left        3.500
  0.000    reference    Lower Right
        31.188    0.000
         Upper Left
      0.000    20.188
       Upper Right
    34.688    20.188
     Upper Middle
  17.344    24.844

     THRUST LINE
  17.344    15.844    Firewall
   set back at 6 degrees (top towards tail).

          Prop Flange (front edge) to
  VERTICAL MOUNT -
   40.625"        Note, from firewall (6
  degree lean back - top towards tail)
   is sin 6 *
   (Thrust Y position) or an additional
   1.656"
   -- end of email ---


   Does this look right?

   Now you want me to lay it back 6 degrees?

   Paul Lamar


        Paul,

  The bottom measurement should be changed from 27.500 to
  27.688"

  Upper middle is 24.844" from the lowest two holes.

  Correct, rotate the firewall back 6 degrees. Point of
  rotation is from
  the lowest two points on the firewall.

  Thank You,

  Tom

  OK Tom Here it is.

  Paul Lamar


       Looks good.

 Bob Barrows, the designer, doesn't have an email account! No computer,
 either! I suspect that is why he gets so much done.

 Thanks,

 Tom

 I'll see Bob at OSH and show him some of this stuff.

 Here are some preliminary 3Ds. Ask questions if you see something
 that looks strange. Upper motor mount is not in yet but we
 will use a rubber ball jointed strut mount to above the water pump.
 Are you using an RX8 engine? That area differs from the 13B.

 Paul Lamar

Paul, am I interpreting the 6 degrees incorrectly...that the mount has 6
degrees of upthrust?  Also, related question, on your mount design that
Jerry has been welding, is the prop flange 90 degrees vertical?

Steve Beckham

No the BearHawk firewall is laid back six degrees. This mount has no down
thrust or side thrust. The down thrust angle can be adjusted however by
using left and right hand threads on the top strut.

Jerry's jig can accommodate down thrust and side thrust.

For the new guys we have been doing these motor mount designs for about
the past seven years. A free service of the newsletter.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.