Subject: 555 mother board
From: Rotary Engine
Date: 6/16/2009, 10:14 AM
To: AAA Put this in the To box

I am working on the 555 mother board layout and connectors
needed. I am already using a straight video connector for the
wire going to the injector from the injector board. These are
automatically self shielding and when you get Teflon dielectric
coax it is burn resistant.

I am thinking of using the right angle version for the mag crank
angles sensor wires as they always seem to be an interference problem.

The advantage of using video coax connectors is they are super cheap
and mass produced world wide. They are made in the billions.
You can also get them in Radio Shack. In some ways they are overkill
as far as the insulation and frequency response is concerned but who cares.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.