Subject: Air assisted direct fuel injection stratified charge for the Wankel
From: Rotary Engine
Date: 6/16/2009, 9:46 AM
To: AAA Put this in the To box



Paul

What has been the discussion so far concerning air assisted direct fuel
injection stratified charge for the Wankel.

It would seem that the wide circumferential depression of the rotor would
allow for optimizing the injection timing and that less loss would occur
from sealing than that of a spark plug with proper tip configuration for the
air-fuel injector nozzle.

This would seem to have the optimize the possibilities of a true stratified
charge with no fuel on the walls of the Wankel to optimize the BSFC.

The injector would possible be of Australian Orbital Tech Group type to be
used in the GM XV-8 Opel Signum 2011. Now since the German
Government owns Opel this is probably in question. Have you heard is GM
planning to use the XV-8 in any US car or truck

Norm

To my knowledge3dge nobody has tried that in a rotary.
The Wankel is naturally stratified charge as the rich mixture
is thrown out towards the plugs due to the rotating combustion
chamber. That is probably why it will run a couple of hundred
degrees F lean of peak. Mixture ratios of 20:1 air fuel.

Paul Lamar

Paul and Norm,

I investigated the Orbital technology, and it would be workable. The biggest
problem is the Orbital people only want to sell to big OEM operations under
license. The minimum that it would cost you to get started is 25K. They
flatly refused to allow any discount to small engineering or prototype
shops. The only way to get what you need otherwise is to get the parts from
a Mercury or other 2 cycle outboard. The trouble is you don't know if the
injectors are going to be close on volume, so you couldn't use the Mercury
control box you would have to use Tracy's or SDS or Megasquirt. The last
item is that you need to run an air pump to feed the injectors which is
engine driven. The cool thing is that Mecury has paired the air pump with the
oil injection pump and you could use that to provide the apex seal oil
without pre-mixing. I was going to do this until I priced some of the
Mercury parts otc. The prices on replacement parts are so jacked up that it
wasn't worth it. I do look for available outboards at the marine shops
occaisionally, but these are the high end of the model line and you don't
see outboards crashed or blown up as often as cars, making parts harder to
come by. I believe that it will be easier to get the direct injection off of
a newer Audi or VW wreck running the Siemens system since there will
be thousands more of them on the road.


Bill Jepson

Don't get your hopes up on direct injection. Getting that to work let
alone work in such a way that it improves the BSFC would take many
thousands of dollars worth of R&D. You can't just install direct
injection and expect it to pay off. I know what Porsche went through
and it was not cheap. I was there when they presented the results. Besides
that they were lucky to get a 5% improvement.

Paul Lamar


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.