We got it back together today in time for the annual EAA project tour.
It's running fine at this point at all rpms. Once it's warmed up well, it
idles with no fuss pretty much anywhere desired from 1400rpm and up. We are
keeping it to around 2000 rpm (700 prop) just to stay consistent with
Lycoming practices. Max static rpm is 6700 (we mapped the high end of the
engine and got an extra 100 rpm out of it for our troubles).
Our new [wide band] O2 sensor still has some peculiar readings at low rpms, but works
as expected at higher rpms. We have a working hypothesis on the behavior
now -- our thinking is that at low rpms just after startup there is not
enough back pressure in the exhaust to keep intake air from finding it's way
into the VAM [muffler] as the rotor sweeps open both the intake and exhaust ports --
thus confusing the O2 sensor. Once the engine is at higher rpm, the exhaust
back pressure prevents this and the O2 sensor settles down.
On the subject of exhaust, the VAM + 1 7/8" down tube has resulted in (I
believe) an engine noise level that is perfectly reasonable. At idle its
not all that much louder than a equally high HP Lycoming, and even at full
power I wasn't needing to cover my ears or anything. I think the fact that
the pitch of the rotary is so much higher vs a recip makes people think it
is louder than it actually is.
I agree the leak was/is so small the suction couldn't pull anything in. It
scares me to think about drilling right next to the PPort tube -- knowing my
luck I'd drill into it vs drilling into the block. Anyway, unless we start
seeing a steady leak under pressure (which we don't) it's going to be left
alone for a while.
mrs
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.