Those numbers are encouraging.
Paul Lamar wrote:
Why dual turbo's? 300 HP is no problem at all with one turbo. Lots of 400
HP one turbo 13B engines out there.
The application is a very high altitude low wing load (<14 lbs /ft2)
carrier
aircraft - payload is a sub orbital spacecraft. I discussed the project
briefly with a few questions a while back - lots of good input. We have
concentrated on the aircraft design since amongst other related project
items. It's now time to finalize the engine choice.
We need a total of 1200 hp at sea level divided either between 2 or 4
engines. They have to be turbo normalized to 50,000 ft to yield the same
1200 hp total output.
This has been done in the past with 2 turbo's inline - the second usually
sized larger for the higher thinner air. In practice 2 appropriately sized
inline turbo's will keep the Hp at 100% to around 50,000. Three turbos
inline with the 3rd quite large has yielded 100% power output to 80,000 ft
plus. (we don't need that high an altitude though).
Given the large propeller of 16 ft diameter for altitude efficiency we are
leaning toward a belt reduction drive (custom made I expect) to get the
9000
or so rpm down to around 800 rpm or so. Maximum thrust for high climb rate
and altitude is the criteria as opposed to high speed.
Brian Feeney
Hello Brian,
It's also possible to get 1:6 pressure ratio from one centrifugal
compressor stage, if that is made the same way as on smaller turboprops.
TCM did it, published 1987:
871041 : Design and Development of a Light Weight, High Pressure Ratio
Aircraft Turbocharger
http://www.sae.org/technical/papers/871041
Also, instead of using SM-3 or similar, have you considered to use a
Bomarc-type lower stage to kick it to ~2 km/s with liquid methane alone?
Almost free lunch, mass-fraction-wise :)
Cheers,
Petri
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.