Subject: 4 vs. 2 rotor all up weight
From: Rotary Engine
Date: 6/19/2009, 8:51 PM
To: AAA Put this in the To box


It's also possible to get 1:6 pressure ratio from one centrifugal
compressor stage, if that is made the same way as on smaller turboprops.

TCM did it, published 1987:
871041 : Design and Development of a Light Weight, High Pressure Ratio
Aircraft Turbocharger
http://www.sae.org/technical/papers/871041

Also, instead of using SM-3 or similar, have you considered to use a
Bomarc-type lower stage to kick it to ~2 km/s with liquid methane alone?
Almost free lunch, mass-fraction-wise :)

Cheers, Petri

Thanks for the reference. I'll get that paper. That would get us 100% power
(turbo normalized) to about 42,000 ft if I am reading the pressure
differential numbers right for a 6:1 boost. That's pretty good and very
close to our 50,000 ft minimum.

I'm an air launch guy with its advantages and disadvantages so the ground
launch booster is not an option. It can be done but there are several safety
issues I don't like - max Q is very high - loss of boost engine near the
ground is very bad as opposed to a pretty benign situation at altitude -
especially with wings - the cabin has to be small for drag purposes relative
to the overall available energy.

The cross section we have is internal width of about 6 ft by about 5 ft oval
in shape and 9 ft long - irregular ovoid - nice amount of room for two to
float in especially considering it is an F16 style canopy covering the whole
cockpit (pilot in the rear). The view and experience will be unparalleled.

The reason for turbo normalizing to 50,000 ft plus (prefer 55,000 to as much
as 65,000 ft) is payload and altitude. 50,000 ft is a good demarcation line
when assessing this. Above 65,000 ft or so is also the limit of any real
benefits. The higher we are in the 50,000 ft through 65,000 ft starting
envelope the longer we can put people in space to further improve the
experience.

I have looked at nitrous oxide or gaseous Oxygen injection along with
methanol for cooling to increase power by about another 25% for a limited
period of time as we near launch altitude - aka WW2 some fighter did this.

Additionally I am looking at electric power boost of 800 hp over the
installed 1200 hp rotary power for about 5 to 9 minutes.

Either of these could mean the difference of having just one turbine instead
of 2 per engine aka the single larger one you refer to.

Note that our criteria is to get to launch altitude and do the drop in 1
hour or less. We also have a desire to launch at as steep a climb angle as
can be managed and is safe (carrier aircraft stall to be avoided!). We will
likely go into a shallow dive, pull up with power to the wall including
whatever form of boost we have to achieve that angle, ideally 45 degrees. It
would be a less than one minute exercise to spacecraft release.

Cheers,


Brian Feeney



-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.