Subject: op amp circuit for 555 EFI
From: Rotary Engine
Date: 6/19/2009, 11:13 AM
To: AAA Put this in the To box

I finally got around to fooling with this
on the bench.

Here is what I came up with. I use a simple voltage divider on
the mass air flow sensor to cut the out put voltage in half.

The op am circuit has a gain of 1 to 2 more or
less adjustable by the pot.

That means if your mass air flow sensor is putting out 4 volts
the input to the amp will be two volts. The op amp
can then put out anything from 2 volts (very lean- gain is one) to 5 volts
super rich (gain is 2.2).

This will compensate somewhat for incorrectly sized MAF
airflow sensors.

Super simple and this goes on the mother board. One for every two
injectors. Part cost is a buck and half not counting the high quality
aircraft grade pot and knob.

Turning the mixture up to full rich will enhance starting.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.