Subject: Leaning potentiometer for 555 EFI
From: Rotary Engine
Date: 6/21/2009, 1:07 PM
To: AAA Put this in the To box


I need some feed back from the pilots
out there that might be using the 555 system.
Here is the leaning pot I found that will solder to the mother board and
poke through the instrument panel.
Also the switches I plan to use.


Another option is to let the builder choose the switches and pots and mount
them remotely from the mother board.
The downside is more skilled labor required to wire them to the mother
board. There will be at least one pot and one switch for every two
injectors. That way the mixture can be adjusted separately for each rotor
based on the EGT.

What do you all think?

I am also looking for somebody
building an EFI engine that would like to try this prototype system on the
ground for free. Let me know where so I can show up when you are ready to
test.

You will need to buy a wide band mixture monitor.

Paul Lamar

OH! OH! Pick me! Pick me!
To answer the questions, for a servicing stand point I would have pots and
switches mounted in panel, and board mounted elsewhere. However, the
components you have speced are perfect and would use them. I'm thinking
having the controls on a little sub-panel that is screwed into it's place on
the main panel. A bit more labor in fabrication, but a lot less when it
comes time to revisit something.
Engine rebuild is in progress, may be a couple months before things are
ready to run. No airplane yet either. Just tail feathers. Plan to mock up a
front end. It was just the way the finances shook out.
Speaking of engine rebuild, the front pully bolt is not cooperating with
removal, my impact wrench is rated for 375FtLbs @ 90psi, any suggestions?
C. Smith

Makes sure the flywheel is locked and use a longer lever.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.