Paul, are the P-port seal blocks and oiler port barbs available for
purchase yet?
Thanks
C. Smith
Will be soon. They are in the shop.
Paul Lamar
Paul
Are you keeping a list for orders? I'd like to add my name if you
are.
Mike C.
No I'll need to start a new list as I lost the old list when I screwed
up my email program.
Paul Lamar
Paul,
Will those blocks work on a 2nd gen rotor housing?
Joe Berki
2nd gen 3rd gen and RX8
Paul Lamar
PAUL YOU CAN PUT ME ON THE LIST FOR THE P PORT SEAL BLOCKS
Jean Prudhomme
OK this is what we are building.
Clean up the rotor housing with a die grinder to make it a smooth curve
and fit the plate. You can grind on the plate too if you need to.
You can also do this in a mill with the housing mounted in the mill
ready to be bored. This speeds the process as a small end mill
can be used to remove excess material.
Use the four holes as pilots to drill (#7) and tap the rotor housing
outer wall for four 1/4 20 or 24 machine screws. After that
is done drill out the four holes in the plate to 1/4 inch.
It will then be bolted to the housing and the 2 inch p-port hole bored
in the plate and in the housing. After the SS tubes are installed and welded
in this part will be unbolted and coated with red RTV on the bottom side to seal the
OD of the tube to the outer housing water jacket. Bolt the plate back on
and your done. You can also pot the water jacket with Devcon Aluminum
Liquid (F-2) 10710 or JB Weld. Not necessary with this plate but it won't hurt.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.