Subject: Leaning potentiometer for 555 EFI
From: Rotary Engine
Date: 6/24/2009, 12:14 PM
To: AAA Put this in the To box



 I need some feed back from the pilots
 out there that might be using the 555 system.
 Here is the leaning pot I found that will solder
 to the mother board and poke through the instrument panel.
 Also the switches I plan to use.


 Another option is to let the builder choose the switches
 and pots and mount them remotely from the mother board.
 The downside is more skilled labor required to wire them
 to the mother board. There will be at least one pot and
 one switch for every two injectors. That way the mixture
 can be adjusted separately for each rotor based on the EGT.

 What do you all think?

 I am also looking for somebody
 building an EFI engine that would like to try this
 prototype system on the ground for free. Let me know
 where so I can show up when you are ready to test.

 You will need to buy a wide band mixture monitor.

 Paul Lamar



Paul,
I vote for remote mount.  Planes are so different.

Joe Berki
Limo EZ



Hi Paul

IMHO, Both-ideas are good.  On the mother board neat and allows tuning
injectors and allows the ability to get around injector and faults etc.

A separate remote mixture is good to. But not four for a two rotor or six
for a triple.

I would go for both, ire as originally suggested with separate pots on the
mother board, for individual rotor tuning and trouble shooting getting round
problems etc.  A separate remote pot, for overall mixture.

I hope I explained it and if that's what was meant already; apologies in
advance.

Come to think of it. I would mount the motherboard flat so if at the top of
the panel I could lift an access panel and change control circuit on the
fly.  Or mount it so the changeable 555 circuits were at the bottom of the
panel all the switches and pots 90 degrees to the circuits like the
alternative injector connecters.

And the remote mixture pot mounted on the throttle lever sort of instead of
the usual knob.  So open and close the throttle and adjust the mixture with
my thumb. (OK that might not work in practice, so I could change it to
operate as a normal mixture lever.)

Hope this helps.

Clive C



-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.