Paul, Anyone
I want to start purchasing AN fittings for the fuel rail I am plan to
make immediately.
Here is my thinking.
Specs
Engine 310 hp. Worst case rail pressure is 75psi. and at that pressure
and 80% duty cycle four Simens Deka IV can delivery 90lbs an hour. Yes
I don't need that hourly volume but because I am injecting in a time
frame that will be less then manifold injection it is helpful. I
suspect this volume is over kill and I can lower the fuel pressure
significantly.
Assume fuel comes in one side of rail and exits the other side. Rail
material and all fittings are SUS 303.
AN-6 on rail fitting is a weld on. It fits to a 3/8" line OD and if
I used a Teflon lined stainless braided hose I should have over 1/4 inch
ID. available. Fuel line however is about 15 feet long.
Wonder if I should go larger?
Question how big a bore should the fuel rail have? 8mm ID?
Doug in Japan
Do you have the Kinsler catalog. You are likely to find the
info in there you are looking for.
http://www.kinsler.com/page--HandbookCatalog--2.html
Paul Lamar
Paul,
Thanks for reminding me. I was never able to download it successfully but
I can view it on line.
Kinsler recommends a large chamber bore in the fuel rail to minimize
pressure spike waves when the injectors open and close. I believe it
was 17.2 mm ID. Looking at the standard Mazda rail I also noticed that
the pipes are quite large. Back to the original plan. I have a piece
of SUS 316 that is 21.7mm OD and 17.7 ID. I'll have to machine some
injector bungs up out of 303 and have them TIG welded on.
Doug in Japan
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.