Subject: Radiant heat damage from VAM
From: Rotary Engine
Date: 7/10/2009, 9:05 PM
To: AAA Put this in the To box


 Hi Paul-

 I was inspecting the lower cowl area after getting the engine running
again
 post-electrical changes.  I noticed that the fiberglass is showing signs
of
 heat damage from the heat coming off the VAM muffler.

 When Mark Steitle was here with his 20b, I saw that he had fashioned a
heat
 shield to cover the exhaust manifold, as well as applied reflective
barriers
 on the fiberglass.

 I ordered some of the reflective barrier for the motor mount tubes &
 fiberglass yesterday.  Getting a similar heat shield around the VAM will
be
 tricky.  And I wonder whether there is some minimum air gap I would have
to
 respect, lest the VAM melt itself.

 Your thoughts??

 Mark (Rocky Mtn High)

 I don't know what that airgap would be. Depends on the effectiveness
 of the insulation. Fiberfrax has a good reputation covered with
 26 gage SS. (very thin)

 Makes sure you get a blast air cooling tube to the center pipe in the
muffler.

 Steve Beckham is putting a metal bubble on his cowl near the exhaust.

 Paul Lamar


Mark,

we use fiberfrax material for a heat barrier against the fiberglass then a
metal heat shield.  Fiberfrax can be found at Wicks or ASS.

Joe Berki
Limo EZ
13b, painting wings


Have you given ceramic coating a thought?
Vlad

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.