Hi Paul

  I am ready to send you money  for those PPort sqare blocs
  and i want to know if you still sell those twin  injectors blocs and how
  much

  Jean Prudhomme

  I am out of those  but I can have some made if some other people
  want them as well.

  How  many want twin injectors mounts for two inch OD intake
  runner  tube?

  Paul Lamar

  I'll take a set if ya make 'em.
  C.  Smith



  Paul,
  I'll take 3 for my 20B

  Don Mitchell

  Ok it would be wise to do them for the RX8 smaller diameter injectors
  like Doug is describing. That seems to be the trend.

  Paul Lamar


  These are the injectors I have, are they what Doug is describing? Blake
also
  has them as he purchased the remaining set of 4 I had.
  C. Smith


  Those are 2nd gen injectors Craig.
  You can get the weld on bosses from Kinsler for those.

  Our new dual block will be for the ones Doug recommends and the
  RX8 size injectors.

  Paul Lamar


Paul,
I think the corvette injectors that I have may fit the holders that you
designed for RX8 stuff.  It is funny that I was just going to start to

build

them based on the HKS dual injector holder design.  Put me down for 2

Joe Berki
Limo  EZ

Send me a picture of what you have and the dims so I can be sure they
will fit.


Paul Lamar

Paul, attached is a sketch with dimensions (numbersin () are millimeters)
and a photo of the injector next to a 2nd gen

Joe Berki

Those are a bit marginal for a p-port engine that uses only 4.
The Corvette uses 8 of those.

Something around 40 pounds is needed or 160 pounds total.
At .65 pounds per HP per hour for 250 HP is 162.5 pounds.
Full chat the rotary BSFC is .65 or so.


Paul Lamar