Hi Paul

I am ready to send you money  for those PPort sqare blocs
and i want to know if you still sell those twin  injectors blocs and how
much

Jean Prudhomme

I am out of those  but I can have some made if some other people
want them as well.

How  many want twin injectors mounts for two inch OD intake
runner  tube?

Paul Lamar

I'll take a set if ya make 'em.
C.  Smith



Paul,
I'll take 3 for my 20B

Don Mitchell

Ok it would be wise to do them for the RX8 smaller diameter injectors
like Doug is describing. That seems to be the trend.

Paul Lamar


These are the injectors I have, are they what Doug is describing? Blake
 also
has them as he purchased the remaining set of 4 I had.
C. Smith


Those are 2nd gen injectors Craig.
You can get the weld on bosses from Kinsler for those.

Our new dual block will be for the ones Doug recommends and the
RX8 size injectors.

Paul Lamar


 Paul,
 I think the corvette injectors that I have may fit the holders that you
 designed for RX8 stuff.  It is funny that I was just going to start to
build
 them based on the HKS dual injector holder design.  Put me down for 2

 Joe Berki
 Limo  EZ

 Send me a picture of what you have and the dims so I can be sure they
 will fit.


 Paul Lamar


Paul, attached is a sketch with dimensions (numbersin () are millimeters)
and a photo of the injector next to a 2nd gen

Joe Berki

Those are a bit marginal for a p-port engine that uses only 4.
The Corvette uses 8 of those.

Something around 40 pounds is needed or 160 pounds total.
At .65 pounds per HP per hour for 250 HP is 162.5 pounds.
Full chat the rotary BSFC is .65 or so.


----------------------------------------------------------

Here is the 3D's of the skinny injector holders  with a Kinsler
dash 8 fuel rail and the RX8 injectors.

These too might be a bit marginal so perhaps you might
want to buy the Siemans that Doug recommends unless of course
you already have the RX8 injectors. The Siemans will fit the same
holder block.

BTW I have a bunch of these weld on bell mouths for two inch
OD .065 wall tubing if anybody wants
a couple. Five bucks each. You know the drill.

Paul Lamar