Hi Paul

 I am ready to send you money  for those PPort sqare blocs
 and i want to know if you still sell those twin  injectors blocs and how
 much

 Jean Prudhomme

 I am out of those  but I can have some made if some other people
 want them as well.

 How  many want twin injectors mounts for two inch OD intake
 runner  tube?

 Paul Lamar

 I'll take a set if ya make 'em.
 C.  Smith



 Paul,
 I'll take 3 for my 20B

 Don Mitchell

 Ok it would be wise to do them for the RX8 smaller diameter injectors
 like Doug is describing. That seems to be the trend.

 Paul Lamar


 These are the injectors I have, are they what Doug is describing? Blake
   also
 has them as he purchased the remaining set of 4 I had.
 C. Smith


 Those are 2nd gen injectors Craig.
 You can get the weld on bosses from Kinsler for those.

 Our new dual block will be for the ones Doug recommends and the
 RX8 size injectors.

 Paul Lamar


   Paul,
   I think the corvette injectors that I have may fit the holders that you
   designed for RX8 stuff.  It is funny that I was just going to start to
 build
   them based on the HKS dual injector holder design.  Put me down for 2

   Joe Berki
   Limo  EZ

   Send me a picture of what you have and the dims so I can be sure they
   will fit.


   Paul Lamar


 Paul, attached is a sketch with dimensions (numbersin () are millimeters)
 and a photo of the injector next to a 2nd gen

 Joe Berki

 Those are a bit marginal for a p-port engine that uses only 4.
 The Corvette uses 8 of those.

 Something around 40 pounds is needed or 160 pounds total.
 At .65 pounds per HP per hour for 250 HP is 162.5 pounds.
 Full chat the rotary BSFC is .65 or so.


 ----------------------------------------------------------

 Here is the 3D's of the skinny injector holders  with a Kinsler
 dash 8 fuel rail and the RX8 injectors.

 These too might be a bit marginal so perhaps you might
 want to buy the Siemans that Doug recommends unless of course
 you already have the RX8 injectors. The Siemans will fit the same
 holder block.

 BTW I have a bunch of these weld on bell mouths for two inch
 OD .065 wall tubing if anybody wants
 a couple. Five bucks each. You know the drill.

 Paul Lamar


Paul,

Do you have the information on the Siemen injectors?  Where can they be
purchased?
I won't use the Vette units if they are too small.  Still interested ina
couple of holders and some bellmouths

Joe Berki

I think Doug had a source for Siemans as I recall. Could be Ballanger Motor
Sports.  The message is probably on my EeePC. Will get that off later today I hope.


Paul Lamar