Subject: 555 EFI and ignition triggers
From: Rotary Engine
Date: 7/13/2009, 7:47 AM
To: AAA Put this in the To box

I have decided to do away with the ABS and crank angle type
magnetic inductive sensors as too expensive and too big. I would have trouble
clearing the water pumps. Klaus has been using hall effect sensors
for years so I am going to copy him. They are cheap at less than
2 bucks each and we need ten. It will only require one small rotating
magnet to trigger the ten sensors. The sensors can be placed
much closer together so the diameter of the trigger system
can be reduced and fit below the water pump.

Klaus's system fits on the prop shaft so it must be much
larger than necessary compared to our e-shaft pulley.

Here are some graphics on the ABS sensor type and the hall data
sheets.

I have lots of experience using optical sensors. They work well and are
cheap and easy to use but they are way too prone to dust and grease.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.