Subject: 13B water pumps and housing combinations
From: Rotary Engine
Date: 7/14/2009, 10:55 PM
To: AAA Put this in the To box


Paul--note to me below from Rob Golden of Pineapple Racing here in Portland
after we talked about water pumps.  Rob has been building these little

engines for street and competition for many years and provided me the
following references regarding pump and pump housing configurations
and differences by year up until the 1993-95 FD3S 13B REW.

In his note below regarding water pump information, I'll remember
his admonition regarding the higher failure rate and keep an eye
on bearing and shaft wear as we work through the dyno tests. It
may be the GMB pumps are less tolerant of too much drive belt
tension loading up the bearings.

Rob has a great web site for Pineapple Racing. When you pull
it up, click on "Company Information" and check out the 20B he
built for a Nike ad and the fuel injected periperal port.
Builds a lot of different configuration, custom work.  Great guy.

By the way, you did a great job on Bulent's water pump.  Those
are terrific reference photos of your exit mod.

Rob wrote:

I do not like the GMB water pumps. I have seen many of them
seize up bearings and shear the pump shaft.

I agree, the cast impeller is much better than the stamped.

All 86 and later motors came with alum. water pump housings,
but steel [cast iron] water pump [housings].

The only difference in mounting to the front plate is the
location of the alternator strap "bolt".
    In the 85 and earlier it was bolted to a "tab" on the
water pump housing.
    86 and later there is a long bolt that goes through the
strap, water pump and housing into the ft. plate.

The 89-91(S5) has extra fasteners holding the water pump
cover to the w/p housing.
The S5 uses a 3 bolt t/state housing unlike the earlier 2 bolt.
The S5 will not clear the S4 and earlier front covers.

I don't know of an all aluminum water pump set up without
using the gmb pumps.

rob

Most of the engines the guys on here run is the 1989 or later.
Tracy recommended that in his book.

Most of these issue went away with the RX8 engine. The water pump
housing is built into the front cover and the outlet is low profile
coming out the side of the front cover. The RX8 cartridge is aluminum
so no need for the GMB pump cartridge.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.