I have decided to do away with the ABS and crank angle type
magnetic inductive sensors as too expensive and too big. I would have trouble
clearing the water pumps. Klaus has been using hall effect sensors
for years so I am going to copy him. They are cheap at less than
2 bucks each and we need ten. It will only require one small rotating
magnet to trigger the ten sensors. The sensors can be placed
much closer together so the diameter of the trigger system
can be reduced and fit below the water pump.
Klaus's system fits on the prop shaft so it must be much
larger than necessary compared to our e-shaft pulley.
Here are some graphics on the ABS sensor type and the hall data
sheets.
I have lots of experience using optical sensors. They work well and are
cheap and easy to use but they are way too prone to dust and grease.
----------------------------------------------------------
This is the one I am going to try. I ordered
a couple from Digikey. The price went up to $6 each but
that beats $16 each for ABS sensor since we need ten.
If it works and I buy more than the price will go down.
We don't have a lot of choice in the matter as the trigger
mechanism will be limited in diameter due to the
proximity of the water pump. These things are tiny so
the circuit board will be small and light weight.
If anybody has any experience using hall effects sensors I would like
to hear about it. Klaus has been using them for quite awhile
so I will also talk to him when I get a chance.
I am worried about the end play on the e-shaft but the Lycoming engine
also has end play. I'll check all that out on the bench.
Paul Lamar
Paul,
The Lycomings end play might be a problem, but I doubt that
the Mazda e-shaft end play would be a problem. The O-200
rebuild video I watched had be chuckling because they
said up to .10 inches was "acceptable"! I don't think my
20B has more than .020 inches if that. Too bad motorcycle
parts are so expensive,several Kawasakis use them for
engine timing. They are small too because they have to
fit inside a motorcycle case.
Bill Jepson
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.