Subject: Hall effect trigger for 555 EFI and ign.
From: Rotary Engine
Date: 7/15/2009, 2:24 PM
To: AAA Put this in the To box


I have decided to do away with the ABS and crank angle type
 magnetic inductive sensors as too expensive and too big. I would have
trouble
 clearing the water pumps. Klaus has been using hall effect sensors
 for years so I am going to copy him. They are cheap at less than
 2 bucks each and we need ten. It will only require one small rotating
 magnet to trigger the ten sensors. The sensors can be placed
 much closer together so the diameter of the trigger system
 can be reduced and fit below the water pump.

 Klaus's system fits on the prop shaft so it must be much
 larger than necessary compared to our e-shaft pulley.

 Here are some graphics on the ABS sensor type and the hall data
 sheets.

 I have lots of experience using optical sensors. They work well and are
 cheap and easy to use but they are way too prone to dust and grease.

----------------------------------------------------------


This is the one I am going to try. I ordered
a couple from Digikey. The price went up to $6  each but
that beats $16 each for ABS sensor since we need ten.
If it works and I buy more than the price will go down.
We don't have a lot of choice in the matter as the trigger
mechanism will be limited in diameter due to the
proximity of the water pump. These things are tiny so
the circuit board will be small and light weight.

If anybody has any experience using hall effects sensors I would like
to hear about it. Klaus has been using them for quite awhile
so I will also talk to him when I get a chance.


I am worried about the end play on the e-shaft but the Lycoming engine
also has end play. I'll check all that out on the bench.

Paul Lamar



Paul,
The Lycomings end play might be a problem, but I doubt that
the Mazda e-shaft end play would be a problem. The O-200
rebuild video I watched had be chuckling because they
said up to .10 inches was "acceptable"! I don't think my
20B has more than .020 inches if that. Too bad motorcycle
parts are so expensive,several Kawasakis use them for
engine timing. They are small too because they have to
fit inside a motorcycle case.
Bill Jepson


Seems like the end play is only critical with one orientation of the
sensor..  On my O-200 with an early LSE ignition, the trigger bolt is
oriented radially and the sensors are mounted outside of that.  End
play has essentially no effect because the sensor's response are is
relatively large in this axis.  If there were significant run out,
there might be a problem..


Matt-

Sounds like you may have one of Klaus's earlier inductive trigger systems.
Are there any rotating magnets?
Can you take a pictures and send it to me?

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.