I have decided to do away with the ABS and crank angle type
magnetic inductive sensors as too expensive and too big. I
would have trouble clearing the water pumps. Klaus has been
using hall effect sensors for years so I am going to copy him.
They are cheap at less than 2 bucks each and we need ten. It
will only require one small rotating magnet to trigger the ten
sensors. The sensors can be placed much closer together so the
diameter of the trigger system can be reduced and fit below the
water pump.
Klaus's system fits on the prop shaft so it must be much larger
than necessary compared to our e-shaft pulley.
Here are some graphics on the ABS sensor type and the hall data
sheets.
I have lots of experience using optical sensors. They work
well and are cheap and easy to use but they are way too prone
to dust and grea
----------------------------------------------------------
This is the one I am going to try. I ordered a couple from
Digikey. The price went up to $6 each but that beats $16 each
for ABS sensor since we need ten. If it works and I buy more
than the price will go down. We don't have a lot of choice in
the matter as the trigger mechanism will be limited in diameter
due to the proximity of the water pump. These things are tiny
so the circuit board will be small and light weight.
If anybody has any experience using hall effects sensors I
would like to hear about it. Klaus has been using them for
quite awhile so I will also talk to him when I get a chance.
I am worried about the end play on the e-shaft but the Lycoming
engine also has end play. I'll check all that out on the bench.
Paul Lamar
Paul, I have looked over the data sheet and app notes for the sensor
you have chosen. You picked an excellent candidate, in that it is a
digital output type sensor, so the sine wave graph that was
posted is not applicable to this type of device.
I believe that temperature will be more of an issue with
stability and repetability than end play. Particularly
if you go with a high flux magnet rare earth magnet for
the trigger. The same company that you suggested for pole
pieces has some good candidates.
http://www.kjmagnetics.com/proddetail.asp?prod=D11
C. Smith
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.