Subject: Hall effect trigger for 555 EFI and ign.
From: Rotary Engine
Date: 7/16/2009, 9:41 AM
To: AAA Put this in the To box


 I have decided to do away with the ABS and crank angle type
 magnetic inductive sensors as too expensive and too big. I
 would have trouble clearing the water pumps. Klaus has been
 using hall effect sensors for years so I am going to copy him.
 They are cheap at less than 2 bucks each and we need ten. It
 will only require one small rotating magnet to trigger the ten
 sensors. The sensors can be placed much closer together so the
 diameter of the trigger system can be reduced and fit below the
 water pump.

 Klaus's system fits on the prop shaft so it must be much larger
 than necessary compared to our e-shaft pulley.

 Here are some graphics on the ABS sensor type and the hall data
 sheets.

 I have lots of experience using optical sensors.  They work
 well and are cheap and easy to use but they are way too prone
 to dust and grea


 ----------------------------------------------------------
 This is the one I am going to try. I ordered a couple from
 Digikey. The price went up to $6 each but that beats $16 each
 for ABS sensor since we need ten.  If it works and I buy more
 than the price will go down.  We don't have a lot of choice in
 the matter as the trigger mechanism will be limited in diameter
 due to the proximity of the water pump.  These things are tiny
 so the circuit board will be small and light weight.

 If anybody has any experience using hall effects sensors I
 would like to hear about it. Klaus has been using them for
 quite awhile so I will also talk to him when I get a chance.

 I am worried about the end play on the e-shaft but the Lycoming
 engine also has end play. I'll check all that out on the bench.



 Paul Lamar


 Paul, I have looked over the data sheet and app notes for the sensor
 you have chosen. You picked an excellent candidate, in that it is a
 digital output type sensor, so the sine wave graph that was
 posted is not applicable to this type of device.
 I believe that temperature will be more of an issue with
 stability and repetability than end play. Particularly
 if you go with a high flux magnet rare earth magnet for
 the trigger. The same company that you suggested for pole
 pieces has some good candidates.
 http://www.kjmagnetics.com/proddetail.asp?prod=D11
 C. Smith


I wonder if the 'cleaned up' signal is all that accurate with varying
end play.  If all they do is run the signal through a comparator, the
output will look good, but the accuracy may not be all that good
depending on RPM and end play..


Matt-

They do more than that.
An amp and a schmidt trigger probably.

We will find out on the bench.

Paul Lamar


How will you check absolute accuracy?  I guess if you have two sensors
at the same angle, one of them with a fixed clearance and one with a
variable clearance you can compare the signal (delta-t on the o-scope)
to see if varying the clearance changes the timing angle.  Not sure
how to check timing vs. RPM..


Matt-

Well as long as it is consistent from rotation to rotation
one can rotate the Hall effect PC board to adjust the exact
timing.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.