How many would be interested in a low cost Teflon slide throttle kit?
 The side plates can be NC punched out relatively cheaply much like an RV
 airplane is pre punched. You can make the Teflon part on a drill press and
 hole saw.

 Paul Lamar



 Definitely count me in for one of those. Will it all fit in a $5 box? ;-)
 C. Smith

 Don't know what it will cost as it won't fit a flat rate box.
 I'll need to weigh it. My guess is metal part will be less than
 2 pounds. It is also about 15 inches long.


 Paul Lamar


 Count me in for one too, Paul.

 Barry Doublestein
 Atlanta Glasair SII FT
 N59BD


Hi Paul

I do have a question,did someone try this device in flight?
did someone face with fuel leaks with this slide throttle kit before??/ Jean
Prudhomme


Not yet but it is going to fly any minute now.

Slide throttle have been used on Mazda racing engines for 30 years.

Yes. We had slide throttle leaks on the original dyno version but we fixed
that with 1/64th (.015) thick gasket material.  Now all raw excess fuel is
captured and runs into the engine.

The engine is running fine and the slide throttle is working slick as snot
according to Mark Suspinski :)

Paul Lamar

Paul--does this system work only with P-port engines, or can it also work
with non-P-port engines as well?  Thanks.
Paul V.

Slide throttles can be made for engines with more intake runners but
this one is made for the two runners of a p-port engine.

Paul Lamar