Subject: Low cost Slide throttle kit?
From: Rotary Engine
Date: 7/16/2009, 10:16 AM
To: AAA Put this in the To box


 How many would be interested in a low cost Teflon slide throttle kit?
 The side plates can be NC punched out relatively cheaply much like an RV
 airplane is pre punched. You can make the Teflon part on a drill press and
 hole saw.

 Paul Lamar



 Definitely count me in for one of those. Will it all fit in a $5 box? ;-)
 C. Smith

 Don't know what it will cost as it won't fit a flat rate box.
 I'll need to weigh it. My guess is metal part will be less than
 2 pounds. It is also about 15 inches long.


 Paul Lamar


 Count me in for one too, Paul.

 Barry Doublestein
 Atlanta Glasair SII FT
 N59BD


I'll take one for a 3-rotor.  ;-)

Mark S.
Austin

I knew you were going to say that Mark :)
Sorry Charlie not enough volume. NC machines
require volume to pay off. The shop owner would laugh
at me if I asked for ten 3-rotor sets.

They are not that hard to make by hand. Find a small shop
that can shear 1/8th thick sheet aluminum material. Then use
a good quality 2 inch hole saw on a drill press. A band saw can cut
the slots. The hardest part is the 3/8th thick spacer but
that can be made from 1/2" by 3/8" bar stock with the corners
tig welded. Grind smooth after welding. We will sell the
throttle cable bracket as that is the same NC mill part.

I did away with all flanges. Just skip tig weld a 1.5 inch
long 2 inch OD .065 wall 6061 tubes to the inner side plate and
connect them  up to the 2 inch SS p-port tubes with silicon hose
and hose clamps.

Paul Lamar

Paul,
I knew that would be your answer...  beginning to feel like a step-child
here.

Too bad this thing isn't modular, so it could be made to work on a 1, 2, 3
or 4 rotor.

Anyway, I had already figured that I would have to build my own.  I plan to
cut the 1/8" aluminum on my table saw.  I've done that before on other
stuff, just need to be very careful, use a sharp blade set to a very shallow
angle, lube it good with WD-40 and take your time.  I can handle the TIG
welding myself.  But how about the teflon slide.  I understand that it isn't
available in long enough pieces to do the slide on a 3-rotor.  Would 1/4"
phenolic work? It is very slippery and available in multiple sizes,
and cheaper than teflon.

Mark S.
Austin

Mark S.

Get a fine tooth carbide blade. They go through aluminum like a hot
knife through butter. I have one in my chop saw and it goes
through 3 inch by 3 inch blocks of aluminum no worries mate.

McMaster Carr has it up to 48 inches long. Be sitting down
when you check the price. I looked into Teflon coating metal.
It is easier than it looks. You buy some Teflon paint for $100
minimum charge. Paint the part and bake it in the Kitchen
oven at 400 F for a couple of hours. Dupont has only one distributor
in the US. I have not tried it yet other than frying eggs in
a Teflon coated frying pan.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.