How many would be interested in a low cost Teflon slide throttle kit?
The side plates can be NC punched out relatively cheaply much like an RV
airplane is pre punched. You can make the Teflon part on a drill press and
hole saw.
Paul Lamar
Definitely count me in for one of those. Will it all fit in a $5 box? ;-)
C. Smith
Don't know what it will cost as it won't fit a flat rate box.
I'll need to weigh it. My guess is metal part will be less than
2 pounds. It is also about 15 inches long.
Paul Lamar
Count me in for one too, Paul.
Barry Doublestein
Atlanta Glasair SII FT
N59BD
Hi Paul
I do have a question,did someone try this device in flight?
did someone face with fuel leaks with this slide throttle kit before??/
Jean Prudhomme
Not yet but it is going to fly any minute now.
Slide throttle have been used on Mazda racing engines for 30 years.
Yes. We had slide throttle leaks on the original dyno version but we fixed
that with 1/64th (.015) thick gasket material. Now all raw excess fuel
is captured and runs into the engine.
The engine is running fine and the slide throttle is working slick
as snot according to Mark Suspinski :)
Paul Lamar
If you run your P Port all over the engine and install
the slide on the sparplug site and injectors location
do you think it can be a difference on performance.
Jean Prudhomme
Not recommended. It hurts the running of the engine at lower
RPMs. You want to keep the throttle as close to the rotor
housing as possible. Steve Beckham on here put the throttles
just inside the rotor housings. At part throttle the runners
store exhaust gas due to valve overlap and make the engine
miss. This was discovered almost as soon as people started
building Wankels. The NSU Wankel spider engine had the throttle
in the p-port rotor housing way back in the middle 1960's.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.