Paul,
I measured the 2-pack injectors on the primary fuel rail when I got home
tonight, Best I can tell, it is 1.0" center to center.
Mark S.
Well I guess it is a die cast housing which might be needed
to feed the injectors. That makes it hard to make one with
an ordinary mill. Here are some old dwgs and pictures of the
fat injector holder. I made this one (one inch center to center)
on my my cheap Chinese mill. Took lots of time.
Paul Lamar
Paul,
Attached is a pic of the part of the fuel rail that I would like to cut off
and use. That may turn out to be a non-option, depending on whether or not
I can find a spare fuel rail.
If push comes to shove, I can always buy some Siemens injectors and use your
injector blocks. Or, go with some of the sdsefi.com injector holders and
use my old injectors.
Mark
Those $40 sdsefi injector holders are pretty nice. Looks like you plumb
each one separately. Will the fat one fit your injectors? It looks
like a top feed. Any idea what the Kinsler injector holders cost?
Do you have access to a mill? I have an idea that might work for you.
Paul Lamar
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.