Subject: 555 EFI and ignition triggers
From: Rotary Engine
Date: 7/20/2009, 9:58 PM
To: AAA Put this in the To box

I have decided to do away with the ABS and crank angle type
magnetic inductive sensors as too expensive and too big. I would
have trouble  clearing the water pumps. Klaus has been using
hall effect sensors  for years so I am going to copy him. They
are cheap at less than  2 bucks each and we need ten. It will
only require one small rotating  magnet to trigger the ten
sensors. The sensors can be placed  much closer together so the
diameter of the trigger system  can be reduced and fit below
the water pump.   Klaus's system fits on the prop shaft so it
must be much  larger than necessary compared to our e-shaft
pulley.   Here are some graphics on the ABS sensor type and
the hall data  sheets.   I have lots of experience using
optical sensors. They work well and are  cheap and easy to use
but they are way too prone to dust and grease.

Paul Lamar


 Paul:

Good luck on the CDI ignition. Here is a link you might enjoy ----on Hall effect triggers: http://www.wellsmfgcorp.com/pdf/Counterpoint3_1.pdf

Regards,


cozy flyr


The date on that article was 1999. Prehistoric times in the
fast changing world of electronics :)


Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.