Paul,

I measured the 2-pack injectors on the primary fuel rail when I got home
tonight, Best I can tell, it is 1.0" center to center.

Mark S.

Well I guess it is a die cast housing which might be needed
to feed the injectors. That makes it hard to make one with
an ordinary mill. Here are some old dwgs and pictures of the
fat injector holder. I made this one (one inch center to center)
on my my cheap Chinese mill. Took lots of time.

Paul Lamar

Paul,
While it would take a careful measurement to tell the difference,
don't you think the measurement would be 25mm
Just checking
Bill Jepson

Probably. .4 mm is 16 thou or .016". Not critical for injector
spacing in this application.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.