Paul, I don't know for sure what overflowed the last attempt at
this. Gmail showed a 15 MB limit and the file was 12.3 MB. The
yahoo limit shows 10 MB so I went to deleting again and got it
below 6MB by eliminating the derivation of the design, inserted
raster immages and anything duplicated. If you get this as
usual-no rights reserved- copy,  redistribute ,  all or any part
that can help anyone. The airframe drawing when pared down this
way is still 108MB. If you want this data_no rights rederved-of
course let me know a mailing address and I will send a cd by
snail mail. The airframe was entered in X-plane at sun-n-fun
2008 by Alex Portalatin at the computer workshop using only
700HP and was extremely stable except for too fast a roll rate
at full stop aleiron inputs and with travel stops that was
solved. at idle power it will come down but any attempt at
dumping altitude to land speed goes uncomfortably fast and it
floats forever. I am considering
 adding spoilers on the wing upper surface which has not yet
been added to the drawings while I sort out the 6 rotor but if
you want a copy of the current design send me a mailing address.


george grimes
                                                                      It was a five meg dwg. I tried loading it into two cad
programs. Rhino could not read it and the other one Qcad
will only accepted dxf.
What cad program are you using?
Can it export dxf, iges or stp files?

The other thing you can try is screen captures.
press the function pri scr key upper right
on the key board. Load MS Paint and paste into MS Paint
then save as a jpg.

If you use Linux the screen capture program saves directly
to a png file which is almost the same as a jpg as most
graphic programs and read it directly. I think the Mac does something
similar but I don't know how to use it.

If that does not work take a picture of the screen with
a digital cameras and send that as a jpg.
Here is an example of that last trick.

Paul Lamar