Jean P,
I know you are interested in this as
you wanted Bulents email address.
Here is some stuff I have on it.
If you need more help let me know.
Tracy's box can be adapted to just about any stock light weight die cast
Mazda bell housing.
Paul Lamar
I'm curious about this as well. Is there a mechanical, or monetary
advantage
to this, over Tracy cook design? Can you buy a partial Tracy cook unit
that
costs less? I do have a transmission laying around.
C. Smith
The advantage is mostly cosmetic. I am not sure Tracy will give
you much off if any for his adapter plate and spacers.
Paul Lamar
Paul, thanks for posing the pictures. As you might recall I a doing cad
work on new side hosings to work with tracy crook's redrive and am
incorporating a taller flange with added bolt holes. It appears from the
pctures that the stock bellhousings areover 5" tall which would be more
material (weight) than the spacers for the redrive.
Ilike the availability
of two starter motor locations on tracy's adapter plate and considered
using
two stock starters on the six rotor by machining tha alternate loation from
the drawings I got off the newsletter. With the taller flange I hope to
make
a more close coupled attachment to the plate. I don't seem to have the
height of tracy's spacers and have been using 3" on the drawings. I am now
compiling the solid models and was wonderingif someone would take a dial
caliper to the spacers that would be used on an RX8 engine and post it on
the newsleter.
george grimes
The stock bell housing are super thin high pressure die castings
.125 inch in some places so they are about the same weight as Tracy's
3 inch high 1/2 inch thick plate set up.
Paul Lamar
Paul, thanks for the quick response. I plan on using Tracy's 1/2 " plate so
the extended flange will be heavier than the spacers in the drive kit.
Another incentive to use magnesium alloy in place of the356 T6 aluminum
for the casting. The solid model buildups are progressing although the
pattern draft isoccasionally a struggle. I joined bunches of features
together in layer to make themeasier to assemble and ge "inconsistant face
edge relationsips" as an error and haven't yet figured out what to avoid
doing this. All parts attempted are working out, just a little extra time to
finish. The front mount for a "P-port" is done and I hope to get the
aluminum section of the front housing done today.
george grimes
You would be better off with Solid works or Rhino. Draft features
are built into Solid Works.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.