This for all you 3 rotor guys building slide throttles.
 We are not going to do a kit as there are not enough
 3 rotors out there to justify the tooling cost.

 There are some parts available such as the 2 inch OD
 connecting tubes and the throttle cable bracket.

 Paul Lamar

 Paul,

 Thanks for doing a drawing for the 3-holer.  Do you have the throttle
 brackets on hand?  How much for one?  Can you put one in with my order of
 tubes and stuff and I'll send you the cash?

 Mark S.

 The throttle brackets will be in the machine shop shortly.

 Paul Lamar


OK, then go ahead and ship my current order and I'll get a throttle cable
bracket when they're available.

Mark

3 injector blocks and 3 bell mouths correct?


Paul Lamar


...and six (6) short tubes.

Mark

OK Mark.

BTW the welder figured out the best way to tig weld the tubes to the 1/8th" thick
covers. Only put the tubes half way through the covers and weld from the
inside. No distortion is noticeable. Covers with welded tubes will be done
tomorrow.

Paul Lamar