Subject: 3 rotor slide dimensions,
From: Rotary Engine
Date: 8/6/2009, 5:11 PM
To: AAA Put this in the To box


 This for all you 3 rotor guys building slide throttles.
 We are not going to do a kit as there are not enough
 3 rotors out there to justify the tooling cost.

 There are some parts available such as the 2 inch OD
 connecting tubes and the throttle cable bracket.

 Paul Lamar

 Paul,

 Thanks for doing a drawing for the 3-holer.Do you have the throttle
 brackets on hand?How much for one?Can you put one in with my order of
 tubes and stuff and I'll send you the cash?

 Mark S.

 The throttle brackets will be in the machine shop shortly.

 Paul Lamar


 OK, then go ahead and ship my current order and I'll get a throttle cable
 bracket when they're available.

 Mark

 3 injector blocks and 3 bell mouths correct?


 Paul Lamar


 ...and six (6) short tubes.

 Mark

 OK Mark.

 BTW the welder figured out the best way to tig weld the tubes to the
  1/8th"
 thick
 covers. Only put the tubes half way through the covers and weld from the
 inside. No distortion is noticeable. Covers with welded tubes will be
done
 tomorrow.

 Paul Lamar


  Paul,

  I was wondering how you were going to get around the distortion issue.
 Good
  solution.

  Mark S.

  My sheet metal shop guy with the welder working for him with dozens of
  years
  experience tig welding sheet metal told me distortion would not be a
  problem.
  I too was skeptical :)


  Paul Lamar

 Paul,
 On the drawing, it shows the teflon slide to be 2.500 wide and the ID of
 the
 frame 2.500.Would .010 clearance between the slide and the inside of the
 frame be sufficient?

 Mark S.

 Would not hurt. I think the aluminum might expand more than Teflon
 with temperature but I could be wrong. Mark Suspinski in Denver has not
 reported
 any problems along those lines.


 Paul Lamar

Paul,
the thermal expansion of the teflon is much greater than the aluminum.
PTFE
is 80 ppm per deg F and aluminum is 13 ppm per deg F.
The slides need to have enough clearance to account for the difference.
The
direction of concern is the height as it will cause binding. Length growth
will effect idle speed.
If you study the models of my design, the correct clearances are in it. I
use spring loaded buttons to control vertical play.
The buttons keep the play to a min when things are cold.
The only time it is an issue is hot soak after shut down. The inlet air
flow
keeps the entire thing pretty stable during normal operation.
Larry

Darn you beat me to the spring loaded button idea :)

Lets see 80 part per million is 8 to the minus 5 or
0.00008 times 2.5 inches or .020 inches at 100 F change. I think if
my arithmetic is good so .010" on either side ought to be OK.

Opss the aluminum is going to get bigger too so it won't be that
much. The aluminum will expand .003" so the clearance would have to
be only .0085" on either side of the Teflon.

Paul Lamar


Paul,
that sound about right. I think I figured it on 120 deg F rise after engine
shutdown.
and just because I beat you to it... doesn't mean you can't use it. If I put
it out here, it is for the benefit of all the members.
:)
Larry


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.