Subject: P-port water passages
From: Rotary Engine
Date: 8/8/2009, 6:24 PM
To: AAA Put this in the To box



George,

Your comment about change in water flow  charteristics when  P-ports are
inserted in a large water passage is a  pertient observation. I
calculated that hole area is over 4.5 cm2. Water  flow in the coolant
system would have to reduce and/or the system back  pressure increase to
maintain stock water flow when blocked.  In  affect it is like shutting a
downstream valve.  I would think we want  higher than stock flow through
the block as we are working the engine at  higher power densities. Anyone
with access to the Mazda Racing housings  could confirm the size of the
holes in the water passages to see if there  is a difference between them
and stock housings.


Doug in  Japan


With the sealing block system water can still flow around the  SS p-port
tube. You don't have to pot the area with epoxy if you are  concerned with
the
water flow in that area. If you do pot it you may be  able to drill
a 1/2 inch dia. or larger water passage. Another possibility  is a small
external return line from the rear rotor housing back to the  input to the
rad.
This is common practice on Chev V8 racing  engines.

I agree that robust water flow is a good thing.

The  blockage is not that bad. You have to figure the percentage of the
total  area blocked and if you look not at the rotor housing but at the
center  housing you will find the center housing side ports block a lot
of the  return water flow.

The bottom line is the metal temperature adjacent to  both the wear surface
and the spark plugs explained in my book How to Cool  Your Wankel.

Mark Steitle installed thermal couples in that location  and found
the temperatures a couple of hundred F below the metal  temperatures
in a Continental  liquid cooled aircraft piston engine. I  have tons of
data on this subject.

IMHO what is far more important  is apex seal temperature which is affected
by rotor cooling and apex seal  oil supply. Hot apex seals wear faster and
the apex seal slot itself wears  faster. In fact the early RX8 with what
turned out to be inadequate oil  supply to cool the apex seals resulted
in less than 100,000 mile life.  Mazda addressed the problem by adding
additional oil injectors about 2007.  I still add a 1/4 ounce of 2 cycle
oil to each gallon of gas in my 2004 RX8  along with the regular
metering pump.


Paul  Lamar

I just checked some factory race Periphery Port housings. At the top of the
 port cavity is a 25/64" [.39"] hole for coolant flow. Just one.

Lynn E. Hanover


Lynn

Very good. Thanks.  I asked because my O-ringed insert PP tube
effectively blocks the water passageway.  There is however enough room
near the outer top of the passageway to remove some metal and allow
water to flow through.  I take it the other cavities holes on the
return side are about the same as stock?

Doug in Japan

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.