Paul, you have inadvertently resolved my "plugs up installation" - it can
be a dead issue with your spur gear PSRU idea, which is an especially good
one.
Only one of these is offered currently, or what I found. If you look at
the "EPI" web address
(
http://www.epi-eng.com/gearbox_products/gearbox_products_contents.htm),
wading through a lot of information, you will find that
they offer a spur gear PSRU with a torsion damping connector, but I can't find
a price which I suspect is high, probably in the neighborhood of $8,000.
Your spur gear idea will move the prop thrust line up more (adjoining
gears) or less (engine driven spur gear with prop driving internal spur gear),
giving you reverse rotation that you can change back with an idler. EPI seems
to have a case split along the shaft axis (see photo), I would think it
makes design and installation of internals less complicated, but I have seldom
seen a axially split case - how strong and reliable would that be? You
mentioned oil passages for constant speed props - you can tap into the case behind
the hollow prop shaft end.
I too have found engine speed and torque capable gears and bearings hard to
find, meaning I have not yet been able to locate any on the web. You may
have to heat treat the gears yourself at the high end of any rotary HP and
torque range.
But I found a place (
http://www.grobinc.com/coldrolled/) that will make
gears for you in long form (like a 24 inch face), kind of like a french bread
stick loaf, and you cut off "slices" as you need them (see photo).
Hope that helps your brainstorming. I am really enthusiastic about this
PSRU idea of yours. Bernie.
Paul who?
I Paul Lamar do not advocate spur gear PSRU's.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.