Subject: pport blocks and tube for slide throttle.
From: Rotary Engine
Date: 8/10/2009, 6:27 AM
To: AAA Put this in the To box


Paul,
I need a couple of the p-port blocks. I also have one of your
slide throttle kits, But it didn't include the four short tubes. Could
I get them also?

--
Blake C. Lewis

You have a slide throttle kit or you want a slide throttle kit?
Take a picture of the kit you have. I forgot I sent out a kit.
If I did and if you have one I might be able to upgrade it
with new tech. Measure the large hole diameter.

Yes you can buy the aluminum tubes now. The 2 inch OD aluminum
tubes are $5 each. Mailing is $5 if it will all fit in
a PO flat rate box.

The SS tubes welded to the liner are more money
as the SS material cost more and they must be contoured on
an NC mill. They are not ready yet. There was a delay in
getting the material. It is cut to length and in the NC shop
now.

Send cash :)

830 East Santa Maria St.
Suite 303
Santa Paula CA
93060

Paul Lamar


Jean Prudhomme wrote:
Good morning Paul

Have you received my cages for PPort installation

Jean Prudhomme

Not yet but I will check with Klaus today.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.