Good morning Paul
I am sending you a sketch the way i am looking the reduction
angle drive with all components ,check it and come back on
your own view
Jean Prudhomme
Nice sketch Jean.
I took the liberty of modifying it the way I think it should be done.
IMHO using u-joints on the prop shaft adds unnecessary weight and
torsional flexibility.
It is up to you of course.
Paul Lamar
Ok Paul do you have any reference of those helicopter bearing and also
could you make a sketch of the complete prop shaft,by the way the main
gear will be at your place in one day and the rest in 3 days
Regarding the prop governer it can be feed true the casing to the
back of housing and fee pressure true middle of the prop shaft.
What is the effect of carbon fiber components to be imbedded all
the time on warm oil???
Jean Prudhomme
I don't know but it is really risky. I did not know you wanted hydraulic
constant speed props. That opens a whole new can of worms. There would
be a lot of oil in a 3 foot long 3.5 inch diameter hollow carbon fiber prop shaft.
200 F oil is bound to have a serious effect on the strength of the epoxy.
Here is some stuff on helicopter AKA thin section bearings.
http://www.timken.com/en-us/Pages/Home.aspx
http://www.timken.com/en-us/products/Pages/Catalogs.aspx
Paul Lamar
-
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.