I don't know but it is really risky. I did not know you wanted hydraulic
constant speed props. That opens a whole new can of worms. There would
be a lot of oil in a 3 foot long 3.5 inch diameter hollow carbon fiber prop
shaft.
200 F oil is bound to have a serious effect on the strength of the epoxy.
Here is some stuff on helicopter AKA thin section bearings.
http://www.timken.com/en-us/Pages/Home.aspx
http://www.timken.com/en-us/products/Pages/Catalogs.aspx
Paul Lamar
Paul,
Marcotte and several others are now using a single plain bearing section to
input the hyd. oil to the prop. Mistral uses a helical drive gear on the
output shaft, which I was going to suggest for the govenor drive. I like that
solution better than the bevel gear, but that is personal preference. If
yoou wanted to do that on the pusher project idea, I would suggest a bearing on
the small section of the spool with a closed cone. Then you need only have
feed lines which are much simpler than filling the shafts with oil. none of
the carbon fiber need even be exposed to the oil.
Bill Jepson
How about a 3D of what you have in mind Bill. I was trying to avoid that
situation due to extra weight and complication. I am trying to get the
weight down to reduce the severe weight penalty of using shaft driven props.
Hence the carbon fiber shafts.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.