Dear Paul
Hi. Smart move using a graphic not a link.
I've been surfing the net to find info about rotary engines and VTOL.
I have a project (still on paper) that incorporates both. I read with
interest, (and some amusement), that you think as I do that helicopters
have had their day.
My project will make that day a reality. (I hope)
What I would like to know is: what is the smallest axial profile
of in-line engines available for a light aircraft, say Cessna or
Piper, comparing perhaps Mazda rotary to Rotax. I know the weight
is less for the rotary, but when all the peripherals are added to
these engines, which would be the slimmer of the two?
From the number of great photos you have on your site, I would
hazard a guess at the Rotax...
Thanks Paul.
I'm off to continue browsing your site.
Best regards
Russ Linley
Nottingham
England
I was just in your neck of the woods last November.
http://www.rotaryeng.net/Oxford-640-4802.wmv
No question a 250 HP 2 cycle would have a smaller frontal area than
a Mazda rotary if you can find one. Lets say a V6 outboard motor.
The fuel burn would be about 135%. Then of course the cooling
might be a problem because outboard engines have an unlimited supply
of cool water to work with. The last factor is the real tie breaker.
Outboard engines are not cheap in that HP range. Have you checked
the price on one lately.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.